Commercial Aluminum 13' 7" Long Walk Ramp Truck, Trailer, Boat, and More

Description

I have 3 good used/take-off aluminum walk ramps as used on many commercial trucks.  They can also be used for trailers, boat docks, loading docks, small bridge use, and much more.  The ramps are in very good condition and were removed because a lift gate was installed on the trucks which covers up access to the ramp compartment.  The average dimensions are:  floor length is 13' 4" to 13' 7" with and overall width of 25.5" and a usable floor width of 23.5".  The height is 4.5" when lying flat on the ground.  These dimensions will be slightly different on each ramp, but will be close.  The ramps have some minor scratches, marks etc. from normal use but no major cuts, dents, missing pieces or damage.  One end has 2 small hooks for holding the ramp in place while in use and handles (rather than the strap shown in the picture) on the other end for pulling the ramp.  The floor is solid non-skid aluminum.  The bottom side has some grease and film on it due to the fact that the ramp is stored in a carrier that is open to the road on the bottom side.  A good pressure wash will take care of most of this.